Introduction: The purpose of this review is to gather and analyse current research publications to evaluate Sinogram-Affirmed Iterative Reconstruction (SAFIRE). The aim of this review is to investigate whether this algorithm is capable of reducing the dose delivered during CT imaging while maintaining …

Aim: Optimise a set of exposure factors, with the lowest effective dose, to delineate spinal curvature with the modified Cobb method in a full spine using computed radiography (CR) for a 5-year-old paediatric anthropomorphic phantom. Methods: Images were acquired by varying a set of parameters: positions …

This research paper has been conducted for X. It presents a new communication strategy for the fund in order to improve its information and increase its effect towards the target audience. Since the First Rutte cabinet (2010) the Dutch cultural sector has been increasingly under pressure from government …

At the biomedical department of the TUDelft a sensor node is designed[1]. This is an Autonomous Wireless Sensor Node(AWSN) with temperature monitoring, which is powered up wirelessly and have data transmission through backscattering. The aim of the project is to design a receiver for the AWSN and to …

This report outlines the origin of aberrations in a Low Energy Electron Microscope (LEEM) and how to measure and automatically correct them. The aberrations in a LEEM are mainly caused by the cathode objective lens and are a limiting factor for the achievable resolution. To optimise the resolution of …

Kipp & Zonen, based in Delft manufactures and develops atmospheric measurement instruments, including a scintillometer. Kipp & Zonen currently manufactures the large aperture scintillometer (LAS) MkII and previously manufactured the extra large aperture scintillometer (XLAS) MkI. A scintillometer can …

A new gravitation wave observatory is being built in Japan. This facility is a big Michelson interferometer where the mirrors and sensors will be made cryogenic down to 4 K. The problem is that: the heat cannot be transported out of the mirror by its surroundings because the whole system is in an ultra-high …

A laboratory test setup is built to transfer and actively stabilize an ultrastable signal, obtained from a laser with sub-Hz linewidth, trough a 5 km long fiber link. The fiber noise is measured and compensated via a feedback loop acting on an AOM that can change the frequency (and therefore the phase) …

Resonance-enhanced laser-induced breakdown spectroscopy was used to increase the elemental sensitivity of laser-induced breakdown spectroscopy. In resonance-enhanced laser-induced breakdown spectroscopy, two lasers are used. The first laser creates a plasma, and the second laser re excites the most …

Research is done on the properties of a niobium superconducting magnetic shield sample (see image below this abstract), its magnetic attenuation; and behaviour around the transition temperature 9.25 K. The attenuation of the magnetic shield sample was measured in a cryogenic setup. This is required to …