This project aims to shorten the time spent on the PLC software development phase when setting up Rohaco transport systems. Developing the PLC software takes a long time and presents an opportunity to be improved. This can be done by automating PLC programming and enabling PLC programmers to start work …

Increasing oil and energy demand asks for higher efficiency when it comes to oil recovery. To increase oil recovery efficiency, pore-scale mechanisms during waterflooding, a common recovery method, have to be better understood. This provides knowledge on the dynamic process during imbibition, which …

Remote maintenance activities in ITER will be performed by a unique set of hardware systems, supported by an extensive software kit. A layer of middleware will manage and control a complex set of interconnections between teams of operators, hardware devices in various operating theatres, and databases …

Experimental setup of motivating physiotherapy clients to perform balancing exercises at home through the use of a game with custom ‘wobble board’ hardware and iPadaccelerometer data.

A laboratory test setup is built to transfer and actively stabilize an ultrastable signal, obtained from a laser with sub-Hz linewidth, trough a 5 km long fiber link. The fiber noise is measured and compensated via a feedback loop acting on an AOM that can change the frequency (and therefore the phase) …

Resonance-enhanced laser-induced breakdown spectroscopy was used to increase the elemental sensitivity of laser-induced breakdown spectroscopy. In resonance-enhanced laser-induced breakdown spectroscopy, two lasers are used. The first laser creates a plasma, and the second laser re excites the most …

A new gravitation wave observatory is being built in Japan. This facility is a big Michelson interferometer where the mirrors and sensors will be made cryogenic down to 4 K. The problem is that: the heat cannot be transported out of the mirror by its surroundings because the whole system is in an ultra-high …

This report is written to guide the reader step by step through the process of developing a heating stage and a iron mapping device for a photoluminescence setup, used to measure the lifetime of silicon wafers in solar cells. Subject specific terms will be explained throughout the report. First, research …

Optical Coherence Tomography (OCT) is an imaging technique for collecting depth resolved information in human tissue based on an interferometer. With an imaging depth of between 1 and 2 mm, OCT is only used to investigate (near) surfaces. But with an axial (depth) resolution of between 2 and 10 μm, and …

Research is done on the properties of a niobium superconducting magnetic shield sample (see image below this abstract), its magnetic attenuation; and behaviour around the transition temperature 9.25 K. The attenuation of the magnetic shield sample was measured in a cryogenic setup. This is required to …